How to Heel and Toe in Sim Racing
|
|
To heel and toe in sim racing, you brake with the ball of your right foot, press the clutch with your left and roll the side of your right foot onto the throttle to blip the engine as you downshift. That blip brings the engine revs up to match the lower gear, so the car stays settled instead of jolting when the clutch comes back up. You'll need three pedals and a manual car, and it usually takes a few weeks of regular practice before it feels automatic. This guide covers the setup, the footwork and a simple way to learn it.
Heel and toe only matters if your car and hardware use a clutch, so check these first:
Before you drive, adjust your pedals so that the brake and throttle faces sit close together when the brake is pressed. If your pedal set allows it, move the throttle towards the brake or tilt its face so your foot can reach both. Don't copy someone else's position. Set it to suit your foot size and the way your brake moves under pressure.
Despite the name, most drivers don't use their heel. Rolling the outer edge of the foot across to the throttle is usually easier, particularly on sim pedals. Use whichever foot position lets you keep steady pressure on the brake.
Start your normal braking in a straight line, using the ball of your right foot on the brake. Keep your foot slightly angled, so the outer edge sits close to the throttle. The brake always comes first, so make sure your foot stays firmly on it.
Wait until you've slowed enough for the lower gear, then press the clutch with your left foot. If you downshift too early, you'll over-rev the engine.
With the clutch down, shift out of gear and start moving towards the next gear down. Keep this motion smooth. Rushing it is a common cause of missed shifts.
Roll the side of your foot onto the throttle for a short, sharp press, while keeping your brake pressure steady. The engine revs need to rise to the speed they'll be running at in the lower gear. The size of the blip depends on the car and how much you've slowed, so use your ears and the rev counter to judge it.
Select the lower gear as the revs rise, then bring the clutch up smoothly. If you've got the blip right, the car won't lurch. Too small a blip will jolt the car and can lock the driven wheels, while too large a blip will push it forward.
If you're dropping more than one gear, repeat the sequence for each one. Finish your downshifts before you turn in, then focus on the corner.
Don't try to learn it at race pace. Start in the pits or on an empty straight in a low-powered manual car. Practise just the blip first, pressing the brake gently while rolling your foot onto the throttle, until you can do it without changing your brake pressure.
Next, add the clutch and one downshift, from third to second at low speed. When that feels comfortable, take it onto a quiet track and use it at one or two corners per lap. A slow, clean shift will always beat a rushed one. Use a replay or your sim's input display to check that your brake line stays smooth when you blip.
You can learn on any three-pedal set, as long as the pedals are close enough for your foot to reach both. An H-pattern lever makes it feel far more complete, and our sim racing shifters collection covers the main options. Check that a shifter suits your platform, as many only work on PC.
The MOZA HGP Shifter is a useful example because it can also do the blip for you. Its intelligent downshift system is selectable in MOZA Pit House, so you can turn it off while you learn the footwork, or leave it on when you'd rather focus on racing.
If you already run a two-pedal MOZA CRP2 set, the MOZA CRP2 Clutch Pedal adds the third pedal you need. A load cell brake moves less than a basic pedal, which is why setting your throttle position matters so much. Our guide to load cell pedals explains how they work, and you'll find more options in our sim racing pedals collection.
Not always. Many modern race cars use paddle shifts and don't need it, and some sims can blip for you. It matters most in older manual cars and road cars, and it can be very satisfying to master.
Not properly. You can practise blipping while you brake, but the full technique needs a clutch pedal.
Older cars often had pedals laid out so that drivers used the toes for the brake and the heel for the throttle. Most drivers now use the ball and the side of the foot, but the name stuck.
You need a clutch. An H-pattern shifter isn't strictly essential, but it's the most natural way to learn the full sequence in a manual car.
It helps you stay smooth, keeps the car settled under braking and avoids locking the driven wheels. The speed comes from that stability, more than from the blip itself.
Take it one downshift at a time, and it'll soon feel natural. If you're adding more hardware to your setup, our guide to sim racing accessories covers what else is worth adding. Gamer Gear Direct is an authorised MOZA Racing dealer, and if you're planning a bigger build, our Dandenong South showroom is open by appointment.
Written by Kurt Ebrado, Sales Manager at Gamer Gear Direct. With over five years of hands-on experience across sim racing and flight simulation gear, Kurt has helped hundreds of Australian sim enthusiasts find the right setup for their space, budget and goals. If you've ever called the GGD showroom for advice, there's a good chance you've already spoken to him.